Service Manual

Steps

1. Note the routing of the antenna, camera, and microphone cables and remove the cables from the routing guides on the middle frame.

2. Disconnect the converter board cable from the display panel and remove it off the middle frame.

3. Remove the eight screws (M3x3) that secure the middle frame to the display panel.

4. Remove the eighteen screws (M3x5) that secure the middle frame to the chassis.

5. Release the middle cover from the tabs on the display assembly.

6. Slide the display cable through the slot on the display assembly.

7. Lift the middle frame off the chassis.

Installing the middle frame

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the middle frame and provides a visual representation of the installation procedure:

Removing and installing components