Service Manual

Steps

1. Slide the system board into the slots on to the middle frame.

2. Align the screw holes on the system board with the screw holes on the chassis.

3. Replace the four screws (M3x5) on to the system board.

4. Install the heat sink assembly to the system board.

5. Connect the converter board cable securely to the system board.

6. Connect the on-screen display cable to the system board and close the latch to secure it.

7. Connect the camera cable securely to the system board.

8. Connect the display cable (LVDS) and secure the connection to the system board.

9. Connect the speaker cable to the system board.

Next steps

1. Install the heat sink.

2. Install the WLAN card.

3. Install the Solid-state drive.

4. Install the memory module.

5. Install the Vesa-mount.

6. Install the back cover.

7. Install the stand.

Removing and installing components