Service Manual

Steps

1. Connect the camera cable to the connector port on the system board.

2. Connect the camera assembly to the tabs on the display bezel.

3. Press the camera assembly into the slot on the display bezel until the securing clip locks in place.

4. Route the camera cable through the routing guides on the middle frame and display bezel.

Next steps

1. Install the back cover.

2. Install the stand.

3. Follow the procedure in After working on your thin client.

System board

Removing the system board

Prerequisites

1. Follow the procedure in Before working inside your thin client.

2. Remove the stand.

3. Remove the back cover.

4. Remove the Vesa mount.

5. Remove the memory module

6. Remove the Solid state drive.

7. Remove the WLAN card.

8. Remove the heat sink.

About this task

The following image indicates the location of system board and provides a visual representation of the removal procedure:

Removing and installing components