Service Manual

Steps

1. Align the captive screws on the heat sink with the screw holes on the system board.

2. In sequential order (as indicated on the heat sink), tighten the four captive screws (M3x7) that secure the heat sink to the system

board.

Next steps

1. Replace the back cover.

2. Replace the stand.

3. Follow the procedure in After working on your thin client.

Coin-cell battery

Removing the coin-cell battery

Prerequisites

1. Follow the procedure in Before working on your thin client.

2. Remove the stand.

3. Remove the back cover.

About this task

The following image indicates the location of coin-cell battery and provides a visual representation of the removal procedure.

Removing and installing components