Service Manual

Steps

1. Align the notch on the solid-state drive with the tab on the solid-state drive slot and slide the solid-state drive into the solid-state drive

slot on the system board.

2. Replace the screw (M2x3.5) that secures the solid-state drive to the system board.

Next steps

1. Install the back cover.

2. Install the stand.

3. Follow the procedure in After working inside your thin client.

Memory module

Removing the memory modules

Prerequisites

1. Follow the procedure in Before working on your thin client.

2. Remove the stand.

3. Remove the back cover.

About this task

The following image indicates the location of the memory modules and provides a visual representation of the removal procedure.

Removing and installing components