Reference Guide

Parameter
* Global overrides identically-named user profile
** After sign off, user profile returns to global value
Description
Device=Wireless
[Mode={Infrastructure, AdHoc}]
[SSID=ssid Channel={1-14}]
[WepKey={None, 1-4}]
[Key1=k1]
[Key2=k2]
[Key3=k3]
[Key4=k4]
[Key1Enc=key1 encrypted]
[Key2Enc=key2 encrypted]
[Key3Enc=key3 encrypted]
[Key4Enc=key4 encrypted]
[RoamSensitive={high, medium, low}]
[Algorithm={Open, SharedKey}]
[DisableBand={None, 2.4G, 5G}]
[PreferBand={None, 2.4G, 5G}]
[Priority=ssid_list]
[DisableN={no, yes}]
[DisableWlan={yes, no, EnetUp}]
[RoamScanChannelTime={1-15}]
[RoamScanChannelProbes={1-4}]
[DriverLogLevel={1-4}]
[DriverDebugLevel={1-7}]
[PowerSaveControl={0, 1}]
[RSSIAmend={}]
Device
— Defines the wireless Ethernet device remotely and
saves to the local NVRAM. Not all options are needed. For example,
you can define Key 1 to have a key of k1 and leave out Key 2
through Key 4.
NOTE: See also IEEE8021X={yes, no}.
General example:
device=wireless SSID=THINOS
RoamSensitive=low
k1 to k4 are any real values of 5 to 13 characters or 10 to 26 Hex
digits. Encrypted keys will overwrite unencrypted keys. Thus, if
both Key1 and Key1 Encare are configured, then Key1Enc will
overwrite Key1.
RoamSensitive — Defines the sensitivity level of wireless roaming
with respect to launching the Roaming daemon:
high - signal lower than -60 dBm
medium - signal lower than -70 dBm
low - signal lower than -80dBm
The RoamSensitive parameter is also used to enable wireless
roaming. If it is not configured in the INI file, roaming will never be
launched even if the signal is lower than -80dbm, unless it totally
loses a wireless signal.
Algorithm — Specifies the authentication method of WEP
between ThinOS and the access point. If set to Open, open
authentication will be selected. If set to ShareKey, shared key
authentication will be selected.
DisableBand — Default is None. Use to disable 2.4G or 5G 802.11
band.
PreferBand —This parameter is used to set the priority of
wireless connection band, and select the 2.4G or 5G access point
to connect. Default is None.
Priority — sets the priority of wireless profiles. The ssid list is
separated by a semicolon or comma and the priority is from high to
low.
DisableN — Default is no. Yes/no option to disable 802.11n Wi-Fi
wireless networking.
Parameters for wnos INI, {username} INI, and $MAC INI files
75