Administrator Guide

Table 13. Admin Policy Tool (continued)
Feature Subfeature Restart required
Network Configuration Proxy Settings No
Network Configuration Wireless Captive Portal requires a reboot to take effect.
Network Configuration Common Settings No
Services VNC Service No
Services WMS Settings No
Services Troubleshooting
Settings
No
BIOS Dell Wyse 3040 Yes, you must restart the client for all changes to take effect.
BIOS Dell Wyse 5070 Yes, you must restart the client for all changes to take effect.
BIOS Dell Wyse 5470 Yes, you must restart the client for all changes to take effect.
BIOS Dell Wyse 5470 AIO Yes, you must restart the client for all changes to take effect.
Important information
● If you are using the Device Security Allow List Policy setting, you must first specify Hub, HID in the Class field by adding
a row in Advanced > Device Security section in Admin Policy Tool. If you do not add Hub, HID to the Allow list, all USB
devices are inaccessible when connected to the thin client. You must restart the thin client for changes to take effect.
● It is not recommended to set Vendor and Product ID and Class simultaneously in one row. However, if you configure both
options simultaneously, the device first checks the Vendor and Product ID followed by the Class list.
● When you configure the Bluetooth, VNCD server, Bluetooth, VNC Server, NetID License, Serial Port, and Device Security
settings using the Admin Policy Tool, ensure that you restart the thin client for the settings to take effect.
Locking the thin client
ThinOS enables you to lock your thin client so that credentials are required to unlock and use the thin client again. This option is
enabled by default. To disable the option, go to Advanced > Login Experience > Login Settings from the Admin Polity Tool
or the Wyse Management Suite Policy Settings, and disable Lock Terminal.
NOTE:
A lock terminal command from Wyse Management Suite takes priority over the settings and locks the thin client
even if the setting is disabled.
Shut down and restart
About this task
This section describes how to use the Shutdown dialog box to either shut down the system or restart the system.
Steps
1. From the desktop menu, click Shutdown.
The shutdown dialog box is displayed.
2. Click any of the following options:
● Shutdown the system—Enables you to shut down the system.
● Restart the system—Enables you to restart the operating system.
3. Click OK to save settings.
42
Getting started with ThinOS 9.1