Reference Guide

Connect Parameter: Options

This appendix provides the supported options for the Connect parameter in the following supported connections:

• ICA Connect Options

• RDP Connect Options

ICA connect options

Table shown here contains the supported options used for ICA connections (after you use the Connect=ICA parameter/selection).

NOTE:

If an option has an underlined value (default), that option and default value will automatically be used with

Connect=ICA; options without underlined values can also be used if you want to, but are not automatically used with

Connect=ICA. In addition, when using options, you can leave the default value or change it to another value shown.

For example, in the following case where:

Connect=ICA

[Option1={0, 1}]

[Option2={1, 2, 3, 4}]

Since you are using Connect=ICA, then Option 1 and its default value 0 will automatically be used as Option 1 has an

underlined value (default of 0). You can still use Option 2 if you want to, however, Option 2 is not automatically used

with the parameter as Option 2 does not have a default value.

NOTE:

Any option in ICA Connect Options that is used in a {username}.ini file will return to the default value set for that option

in the wnos.ini file after a user sign-off. For example, if your {username}.ini file contains the option Reconnect=yes so

that a lost connection will restart 20 seconds after disconnection; and you sign off the thin client, then the Reconnect

value will return to the original default value of no (Reconnect=no) contained in the wnos.ini file—so that others who

ICA connect: options

Table 13. ICA connect: options

Option Description

Alternate=[no, yes] Default is no.

Yes/no option to use an alternate IP address returned from an ICA

master browser to get through firewalls.

AudioQualityMode={0, 1, 2, 3} Default is 0.

Specifies the audio quality of a session.

0 – Default

1 – High Quality

2 – Medium Quality

3 – Low Quality

Connect Parameter: Options 89