Reference Guide

Parameter
* Global overrides identically-named user profile
** After sign off, user profile returns to global value
Description
[mic_gain_device={device name string}]
[mic_gain={1~8}]
[DPaudio=yes,no]
[local_button=yes, no]
[jack_popup=[yes, no]
[PlayBackEnableList={device name string}]
[RecordEnableList={device name string}]
[EnableReplay=[yes, no]]
3 — mutes system beep
mic_vol — Default is medium. Option to set volume levels to
high, middle or low.
high — maximum volume
middle — medium volume
low — minimum volume
Values of 0-25 provide more exact volume level.
mic_mute — Default is no.
no — no mute
yes — mutes audio
mic_ boost — This option increases the mic decibels.
min_cache — Default is 1. This option is for configuring ThinOS
audio playback minimum buffering amount in ten millisecond units.
This can be used when network bandwidth is not large enough to
play audio smoothly.
In such cases, set min_cache higher, so that ThinOS will buffer
more audio data before playing the audio.
1 – ThinOS will buffer at least 10 ms of audio data when playing
audio.
50 – ThinOS will buffer at least 500 ms (0.5s) of audio data when
playing audio.
EnableSpeaker — Default is yes. Yes/no option to enable the
internal loud speaker.
playback — You can set a playback device name.
record — You can set the record device name.
mic_gain_device— Specify the device name on which you want
the mic gain.
mic_gain—Enhances the mic gain by number of times the
specified value. The default value is 1.
Continued from the previous table...
DPaudio=[yes, no]— The default option is DPaudio=yes. DP
audio may impact display on device with certain screen resolutions
such as 1920x1200, 2048x1152, 2048x1280, 2560x1080,
2560x1440 (U2718Q, UP3216Q) however not limited. User needs
to disable DP audio using INI or GUI.
This setting only works for terminals with DP audio support.
local_button=[yes, no] The default option is yes, if the value is
no, the mute/volume up/volume down buttons are disabled in
ThinOS local, but it works during session
jack_popup— The default option of jack_popup is yes. If the
jack_popup is set to no, jack selection message display is disabled
when the jack headset is plugged in.
The PlayBackEnableList and RecordEnableList—Enables you to
specify the list of audio devices that are mapped to an ICA session.
You can separate each audio device with a comma.
Parameters for wnos INI, {username} INI, and $MAC INI files 55