Reference Guide

[VWGateway]=url
[ConnectionType]={Default, All, RDP, PCoIP}
Set IgnoreProle=yes to disable parsing the global setting from the
VDI broker. It is only valid in the case of ConnectionBroker=default.
SecurityMode — SecurityMode species the security mode for
the VMware broker and Amazon Workspace (AWS) broker. It is only
valid in case of ConnectionBroker=VMware or
ConnectionBroker=AWS. The details is as follows:
• Set SecurityMode=Full to have the Client verify the server's
certicate in highest security mode; if any relevant checks error,
it will fail to connect to the server.
• Set SecurityMode=Warning to have the Client allow connection
continuation in the following two specic exceptions where full
verication would fail:
a Certicate is self-signed.
b Certicate has an invalid time.
• Set SecurityMode=Low to indicate that Client allows
connection without any certicate verication.
• Set SecurityMode=Default to indicate that Client follows the
SecurityPolicy setting to verify the certicate.
NOTE:
For Dell vWorkspace broker, ConnectionBroker=Quest is
recommended.
EnableVWGateway and VWGateway are used to set the
vWorkspace gateway.
For VMware broker, ConnectionBroker=VMware is
recommended. ConnectionBroker=VDM is still supported but
deprecated.
The option ConnectionType species the display protocol that you
want to use when launching a session in VMware broker. If this
parameter is set, then the desktops that meet the specied
protocol are listed after broker sign on.
This setting is only valid in case of PCoIP feature is supported.
• Set ConnectionType=Default, only the desktops with the
default protocol congured in broker server are listed (this is the
default value for this setting).
• If you set ConnectionType=All, both PCoIP and RDP desktops
are listed.
• If you set ConnectionType=RDP, only RDP desktops are listed.
• If you set ConnectionType=PCoIP, only PCoIP desktops are
listed.
DelCerticate={lename,
all, builtin}
lename — Removes the named le from the nand ash or from
the memory.
all — Removes all certicates except built-in certicates included
by default.
builtin — Removes all certicates including the public certicates
included by default.
DesktopColorDepth={16, 32}
[RGB565={no, yes}]
DesktopColorDepth — Sets the desktop color to 16 or 32 bits. If
DesktopColorDepth=16, the default color is 15 bits.
Parameters for WNOS INI Files Only 21