Release Notes

INI parameters Description
[ACRecovery={PowerO, PowerOn, LastState}]—This option
species how the system behaves when AC power is restored after
an AC power outage.
• PowerO—System stays o after AC power is restored.
• PowerOn—System powers on after AC power is restored.
• LastState—System keeps the last power state as the last/
previous state of the system was before AC power was
removed.
[USBRearPort={yes, no}]—If yes is specied, devices attached to
the rear USB port are enabled, and available for operating system. If
no is specied, operating system cannot detect any devices
attached to the back USB port.
NOTE: USB keyboard and mouse always work in the BIOS
setup irrespective of this setting.
[USBFrontPort={yes, no}]—If yes is specied, devices attached
to the front USB port are enabled and available for operating
system. If no is specied, operating system cannot detect any
device attached to front USB port.
NOTE: USB keyboard and mouse always work in the BIOS
setup irrespective of this setting.
[WakeOnLan={Disable, LAN, PXE}]—This option allows the thin
client to power up from the o state when triggered by special LAN
signal. Wakeup from the standby state is unaected by this setting
and must be enabled in the operating system. This feature only
works when the thin client is connected to AC power supply.
• Disable—Do not allow the system to power on by special LAN
signals when it receives a wake up signal from the LAN or
wireless LAN.
• LAN—Allows the thin client to be powered on by special LAN
signals.
• PXE—A wake up packet sent to the system in either the S4 or
S5 state causes the system to wake up, and immediately boot
to PXE.
[WakeOnUSB={yes, no}]—WakeOnUSB allows the computer to
power up from the o state when triggered by USB signal. Wakeup
from the standby state is unaected by this setting and must be
enabled in the operating system. This feature only works when the
computer is connected to AC.
• If yes is specied, wake on USB is enabled.
• If no is specied, wake on USB is disabled.
[USBBootSupport={yes, no}]—If yes is specied, device allows
operating system to boot from USB port. If no is specied, the
operating system cannot boot device from USB port.
NOTE
: USB, keyboard, and mouse always work regardless
of being specied or not.
[PXEBootSupport={yes, no}]—If yes is specied, device allows
operating system to boot from PXE. If no is specied, the operating
system cannot boot device from PXE.
ThinOS 8.5_107
43