Release Notes
Figure 11. Ports on Wyse 5070 Extended thin client
Monitor priority—The following order denes the monitor priority set on ThinOS for Wyse 5070 Extended thin client:
• DP1 > DP2 > DP3 > mDP4 > mDP5 > DP6
• DP1 > USB Type-C > DP3 > mDP4 > mDP5 > DP6
• DP1 > DP2 > VGA > mDP4 > mDP5 > DP6
• DP1 > USB Type-C > VGA > mDP4 > mDP5 > DP6
NOTE
: Monitor cable hot plug—Screen layout settings are changed based on supported monitor resolution and the port to
which the monitor is plugged in.
NOTE: Earlier in ThinOS zero theme, the Display Setup window was aligned with left-hand setting panel. In current scenario, the
Display Setup window is positioned to center of the screen regardless of Classic/Zero mode. This enhancement is made to easily
congure the display setup along with the conrmation window.
INI parameters—The INI parameters for display in Wyse 5070 thin client are from ThinOS 8.5 legacy INI. The INI parameter supports only
two monitors, that is, the INI settings can only impact the rst two screens. If you add the third screen, it follows the display settings
dened for the second screen. There are few settings that are not applicable for Wyse 5070 thin client with ThinOS. For more information,
see INI parameters. Further solution on INI settings for Wyse 5070 thin client with ThinOS is provided post RTS.
ThinOS 8.5_107
33