Setup Guide

Values of 0-25 provide more exact volume level.
mic_mute — Default is no.
no — no mute
yes — mutes audio
mic_ boost — This option increases the mic decibels.
min_cache — Default is 1. This option is for conguring ThinOS
audio playback minimum buering amount in ten millisecond units.
This can be used when network bandwidth is not large enough to
play audio smoothly.
In such cases, set min_cache higher, so that ThinOS will buer
more audio data before playing the audio.
1 – ThinOS will buer at least 10 ms of audio data when playing
audio.
50 – ThinOS will buer at least 500 ms (0.5s) of audio data when
playing audio.
EnableSpeaker — Default is yes. Yes/no option to enable the
internal loud speaker.
playback — You can set a playback device name.
record — You can set the record device name.
mic_gain_device— Specify the device name on which you want
the mic gain.
mic_gain—Enhances the mic gain by number of times the
specied value. The default value is 1.
DPaudio=[yes, no]— The default option is DPaudio=yes. DP audio
may impact display on A10Q with certain screen resolutions such as
1920x1200, 2048x1152, 2048x1280, 2560x1080, 2560x1440
(U2718Q, UP3216Q) however not limited. User needs to disable DP
audio using INI or GUI.
This setting only works for terminals with DP audio support (A10Q,
D10Q, and U10).
local_button=[yes, no] The default option is yes, if the value is no,
the mute/volume up/volume down buttons are disabled in ThinOS
local, but it works during session
Device=bluetooth
[Disable={yes, no}]
Set the parameter to disable bluetooth devices. The default value is
no. The value is stored into NVRAM. If you set Disable=yes, the
bluetooth devices are not initialized.
Device=MIC
[Disable={yes, no}]
Device=MIC—This option enables or disables microphone devices.
The default value is no and the value is stored in NVRAM.
If the value is set to Disable=yes, the microphone devices are not
registered to the system.
Device=camera
[format=raw]
[width={camera supported width}]
Specify the ThinOS local camera settings.
format — Support only for raw video type; format=raw is xed.
width — The width of the resolution that the local camera
supports.
62 Parameters for wnos INI, {username} INI, and $MAC INI les