Reference Guide

Parameter Description
SSID=Wyse Security=leap \
Mode=Infrastructure \
Username=admin \
Password=1234567890 \
AuthType LEAP example:
WLAN=wlan6 SSID=ACS \
Security=wpa&wpa2enterprise \
Mode=Infrastructure \
AuthType=leap \
Username=linux\
Password=linux\
AuthType PEAP example:
WLAN=W2EN \
SSID=W2EN \
Security=wpa&wpa2enterprise \
Username=peap \
Password=peap \
AuthType=peap \
InnerAuth=mschapv2 \
PeapVersion=Auto \
CACertificate=/etc/certificate/rootcer.cer\
802.1x parameter for wired network
The following table contains the 802.1x parameters for wired network:
NOTE: You must enter the parameters on the same line.
Table 6. 802.1x parameters for wired network
Parameter Description
Enable802={no, yes}
Default is no. This option enables or disables the 802.1x settings for the Auto Eth0 wired
connection.
Authentication={TLS, PEAP} This option enables you to select the EAP method for 802.1x authentication.
[PromptPassword={no, yes}] Default is no. This option initiates the authentication for 802.1x. and prompts you to enter the
password every time the network connection is established.
[InnerAuthentication={MSCHAPv2}] This option enables you to specify the inner authentication protocol for EAP PEAP.
[UserCertificate=<certificate name>] This option specifies the client or user certificate name that is used for TLS authentication.
[CACertificate=<certificate name>] This option specifies the Root CA certificate name for authentication.
[PrivateKey=<certificate name>] This option specifies a client or user private key certificate that is used for TLS
authentication.
[PrivateKeyPassword=<password>] This option specifies the base64 encoded password that is required during the creation of a
user or client certificate.
[AuthMode={Machine, User}] This option enables you to either set the machine authentication mode, or user
authentication mode for TLS.
Connection Settings Parameter Options 29