Reference Guide

Parameter Description
MON1 primary rotate-left 1920x1080 MON2 1920x1200 MON3
1920x1200
rotate-left, rotate-normal, and rotate-right are supported as legacy
parameters. These parameters rotate the framebuffer for monitors that
do not actually support rotation. Specifying these parameters requires
monitors to be physically rotated. For monitors that support rotation,
these parameters are not necessary.
<default>
This key value is to reset both monitors to default settings. (Optimal
resolutions in horizontal placement and MON1 on the left as primary
display).
DDC
Resets all the monitors to default layout and default resolutions – The
default layout is all in HORIZONTAL placement, Primary is MON1 and
resolutions are optimal.
Horizontal
For Example: DisplaySettings=Horizontal (which is equal to
DisplaySettings= <default>) OR DisplaySettings=Horizontal MON1
primary 1920x1080 MON2 1920x1200 MON3 1920x1200
This single Horizontal (with capital H) key value without any parameter
is used to reset both the monitors to DDC mode as it is in default
settings. There can be parameters as in MON1 MON2 and MON3
format as described above. The result is to set the monitors in horizontal
placements with specified individual parameters.
Vertical
For Example: DisplaySettings=Vertical (which is equal to
DisplaySettings= <default>) OR DisplaySettings=Vertical MON1 primary
1920x1080 MON2 1920x1200 MON3 1920x1200
This single Vertical (with capital V) key value is used to set both
monitors to DDC resolutions, but in vertical placement with default
MON1 on the top.
MON3...MON2 … MON1…
With individual monitor with their specific parameters in place, but
swaps the MON2 at the beginning of the string, followed by MON1 will
be placed MON2 on the left and MON1 on the right. This is equivalent of
MON1 on-right MON2 on-left. For Example: MON2 MON1 = MON1 on-
right MON2 and MON3on-left
Mirror <rotate {normal, left, right, inverted}, {resolution}>
It sets the monitors in mirror mode with given resolution and rotation.
DisplaySettings=MON1<resolution=1920x1080>MON2<resolu
tion=1920x1200>MON3<resolution=1920x1200>
Example for single display
DisplaySettings=MON1 rotate-normal
1366x768
DisplaySettings=MON1 rotate-left 1366x768
DisplaySettings=MON1 rotate-right
1366x768
DisplaySettings=MON1 rotate-inverted
1366x768
This section is applicable to the Wyse 5470 Thin Client.
This parameter enables you to configure the display settings.
NOTE: The values are case-sensitive.
The following are the rules for display settings:
• MON1, MON2, MON3 are the mandatory constant values for
display 1, display 2, and display 3 respectively.
• To specify resolutions, use the 1920x1080 format. Resolutions are
optional. If not specified, DDC (optimal) resolutions are used.
For example, DisplaySettings=MON1 1920x1080 MON2 1920x1200
MON3 1920x1200
Peripheral Settings Parameter Options 17