Administrator Guide

Table 12. Ericom PowerTerm login settings

Parameter Description

Connection type On the Connection Type page, click the Network or Serial Port

radio button depending upon the requirement. By default, the

Network option is selected. Serial Port radio button is disabled if the

application does not detect any active serial ports.

Host Enter the Ericom server host’s IP or FQDN address in the Host field.

This field is hidden, if the connection is through Serial Port.

Port Specify the port number used to connect the Ericom server in the

Port field. This is available if the connection is through the network.

In case of Serial Port, this field displays as COM port and the

available serial ports are listed in the drop-down list.

Terminal type Select the terminal type to be emulated from the drop-down list in

the Terminal Type field.

Terminal name Type the name of the Ericom PowerTerm terminal window in the

Terminal Name field

Script file to run on logon Specify the path of the script file (if any) to be executed in the

remote system in the Script file to run on Logon field.

Remote configuration file Specify the location of the remote configuration files in the Remote

configuration file field.

Auto-connect after login

a. Click the ON/OFF button to enable or disable the Auto-connect

after login option. If enabled, the connection is automatically

connected after you log in to your thin client.

b. Click the ON/OFF button to enable or disable the Auto-

reconnect after disconnected option. If enabled, the connection

is automatically re-connected after you disconnect from the

session.

c. Select the time duration in seconds to delay the reconnection

attempt after a disconnection occurs.

4. The following options must be configured in the Experience tab.

Configuring Connections locally