Users Guide
Table Of Contents
- Dell Wyse 3040 Thin Client User Guide
- Welcome to Dell Wyse 3040 thin client
- Wyse 3040 thin client hardware installation
- Wyse 3040 thin client on ThinOS
- Logging on to the Wyse 3040 thin client running Wyse ThinOS
- Configuring the dual head display settings in Dell Wyse ThinOS
- Configuring the network settings on Dell Wyse ThinOS
- Configuring peripherals settings on Wyse ThinOS
- Power state
- Configuring the broker setup on Dell Wyse ThinOS
- Configuring the WDA settings on Dell Wyse ThinOS
- Wyse 3040 thin client on ThinLinux
- Accessing thin client BIOS settings on Wyse ThinLinux
- Logging on to the Wyse 3040 thin client running ThinLinux
- Configuring display on Dell Wyse ThinLinux
- Configuring the network settings on Dell WyseThinLinux
- Configuring peripherals settings on Wyse ThinLinux
- Power state
- Configuring connections locally on Dell Wyse ThinLinux
- Configuring WDA settings on Dell Wyse ThinLinux
- Major components of your system
- System specifications
- Thermal management on Wyse 3040 thin client
- BIOS overview
- Accessing thin client BIOS settings
- System Setup overview
- Boot Sequence
- Navigation keys
- General screen options
- System Configuration screen options
- Security screen options
- Secure Boot screen options
- Performance screen options
- Power Management screen options
- POST Behavior screen options
- Virtualization support screen options
- Maintenance screen options
- System Log screen options
- Updating the BIOS
- Troubleshooting your system
Table 17. Diagnostic power LED codes
Power LED light status Possible cause Troubleshooting steps
● Defect cable or connector
Distorted display Should have normal viewable display.
● Incompatible monitor
● Incompatible dongle (if used)
● Not supported display mode
● Bad connection on display output
● Logic board defect
Power LED error code behavior
Table 18. Power LED error code behavior
LED# of flashes Fault description Fault Action Comment
2,1 CPU CPU Failure Type A
2,2 Motherboard: BIOS ROM
failure
Motherboard, covers
BIOS corruption or
ROM error
NA Not applicable to X7
BIOS. No Test Case
support.
2,3 Memory No Memory/RAM
detected
NA Not supported. Memory
is solder down on
Motherboard. It is
difficult to validate this
function.
2,4 Memory Memory/RAM failure Type A Supported. Memory
is solder down
on Motherboard,
the Service team
could replace the
motherboard/memory
to repurpose the board
for repair.
2,5 Memory Invalid memory is
installed
NA Memory is solder down
on motherboard.
2,6 Motherboard: Chipset Motherboard / Chipset
error
NA This code is
not supported. HW
dependent.
2,7 LCD LCD failure NA This code is not
supported. There is no
LCD.
3,1 RTC Power failure CMOS battery failure Type B
3,2 PCI / Video PCI or Video card/ Chip
failure
NA Not applicable to X7
BIOS. No test case
support.
3,3 BIOS Recovery 1 Recovery Image not
found
Type A
3,4 BIOS Recovery 2 Recovery Image found
but invalid
Type A
4,1 CPU Config or CPU
Failure
NA This code is not
supported.
62 Troubleshooting your system