Users Guide

5. Click Bridge to add and configure the bridge network connection for your thin client.
a. Click the Bridge tab, and configure the following options:
i. Interface name — Type the name for your network interface.
ii. Bridged connections — The number of bonded connections that are set up are listed here. To add a new bond
connection, click the Add button and select the type of connection you want to create. The available options are
Ethernet, Wi-Fi, and VLAN.
iii. Aging time — Enter the Aging time duration in seconds.
iv. Enable IGMP snooping—Select this check box to monitor Internet Group Management Protocol (IGMP)
communications among devices.
v. Enable STP — Select this check box to enable the Spanning Tree Protocol (STP) for your connection.
vi. Priority — Enter the priority value.
vii. Forward delay — Enter the forward delay duration in seconds.
viii. Hello time — Enter the hello time duration in seconds.
ix. Max age — Enter the value for the maximum age.
b. To configure the General tab, IPv4 Settings tab, and IPv6 Settings tab for Bridge connection, see the configuration
details for Bond connection in this section.
6. Click VLAN to add and configure the VLAN network connection for your thin client.
a. Click the VLAN tab, and configure the following options:
i. Parent interface — Type the name for your parent interface.
ii. VLAN ID — Enter the value for the VLAN id.
iii. VLAN interface name — Type the name for your VLAN interface.
iv. Cloned MAC address — Type the cloned MAC address.
v. MTU —Specifies the size (in bytes) of the largest protocol data unit that the protocol layer can pass onwards.
vi. Flags—Select the Reorder headers, Generic VLAN Registration Protocol (GVRP), Loose binding, and Multiple VLAN
Registration Protocol (MVRP) check boxes to enable the respective functions for your VLAN connection.
b. To configure the General tab, IPv4 Settings tab, and IPv6 Settings tab for VLAN connection, see the configuration
details for Bond connection in this section.
7. Click Save to save your settings.
Configuring peripherals settings on Wyse ThinLinux
On the System Settings page, click the Peripherals icon. The following tabs are displayed on the left pane of the System
Settings page.
● Keyboard
● Mouse
● Printers
● Sound
Setting the keyboard preferences
The Keyboard setting page enables you to set the Keyboard preferences and make the Keyboard layout.
NOTE:
By default, the Keyboard screen is available in both User mode and Admin mode. Any changes made through
Keyboard preferences screen is saved and continued for the built-in thinuser
38 Wyse 3040 thin client on ThinLinux