Users Guide
Table Of Contents
- Dell Wyse 3040 Thin Client User Guide
- Welcome to Dell Wyse 3040 thin client
- Wyse 3040 thin client hardware installation
- Wyse 3040 thin client on ThinOS
- Logging on to the Wyse 3040 thin client running Wyse ThinOS
- Configuring the dual head display settings in Dell Wyse ThinOS
- Configuring the network settings on Dell Wyse ThinOS
- Configuring peripherals settings on Wyse ThinOS
- Power state
- Configuring the broker setup on Dell Wyse ThinOS
- Configuring the WDA settings on Dell Wyse ThinOS
- Wyse 3040 thin client on ThinLinux
- Accessing thin client BIOS settings on Wyse ThinLinux
- Logging on to the Wyse 3040 thin client running ThinLinux
- Configuring display on Dell Wyse ThinLinux
- Configuring the network settings on Dell WyseThinLinux
- Configuring peripherals settings on Wyse ThinLinux
- Power state
- Configuring connections locally on Dell Wyse ThinLinux
- Configuring WDA settings on Dell Wyse ThinLinux
- Major components of your system
- System specifications
- Thermal management on Wyse 3040 thin client
- BIOS overview
- Accessing thin client BIOS settings
- System Setup overview
- Boot Sequence
- Navigation keys
- General screen options
- System Configuration screen options
- Security screen options
- Secure Boot screen options
- Performance screen options
- Power Management screen options
- POST Behavior screen options
- Virtualization support screen options
- Maintenance screen options
- System Log screen options
- Updating the BIOS
- Troubleshooting your system
Figure 8. Hidden Wi-Fi Network
5. Enter the name and security details of the hidden network that you want to connect to.
Table 3. Hidden network
Parameter Description
Network name Enter the preferred network name.
Wi-Fi security From the drop-down list, select the security type.
6. On the Network page, click the History button to view the previous Wi-Fi connections and details.
Configuring wired network connection settings
To configure the wired connection settings, perform the following steps:
1. Click the Wired tab. The following attributes are displayed if the network cable is connected to your thin client and wired
connection is established.
● IPv4 Address
● IPv6 Address
● Hardware Address
● Default Route
● DNS
NOTE: After the network is disconnected, only hardware address and last used information are displayed.
2. On the lower-right corner of the page, click the Settings icon to configure the Wired Network connections.
3. Click the Details tab to view the following attributes:
● Link Speed
● IPv4 Address
Wyse 3040 thin client on ThinLinux
33