Users Guide
Table Of Contents
- Dell Wyse 3040 Thin Client User Guide
- Welcome to Dell Wyse 3040 thin client
- Wyse 3040 thin client hardware installation
- Wyse 3040 thin client on ThinOS
- Logging on to the Wyse 3040 thin client running Wyse ThinOS
- Configuring the dual head display settings in Dell Wyse ThinOS
- Configuring the network settings on Dell Wyse ThinOS
- Configuring peripherals settings on Wyse ThinOS
- Power state
- Configuring the broker setup on Dell Wyse ThinOS
- Configuring the WDA settings on Dell Wyse ThinOS
- Wyse 3040 thin client on ThinLinux
- Accessing thin client BIOS settings on Wyse ThinLinux
- Logging on to the Wyse 3040 thin client running ThinLinux
- Configuring display on Dell Wyse ThinLinux
- Configuring the network settings on Dell WyseThinLinux
- Configuring peripherals settings on Wyse ThinLinux
- Power state
- Configuring connections locally on Dell Wyse ThinLinux
- Configuring WDA settings on Dell Wyse ThinLinux
- Major components of your system
- System specifications
- Thermal management on Wyse 3040 thin client
- BIOS overview
- Accessing thin client BIOS settings
- System Setup overview
- Boot Sequence
- Navigation keys
- General screen options
- System Configuration screen options
- Security screen options
- Secure Boot screen options
- Performance screen options
- Power Management screen options
- POST Behavior screen options
- Virtualization support screen options
- Maintenance screen options
- System Log screen options
- Updating the BIOS
- Troubleshooting your system
● Broker Server— Enter the IP address of the Broker Server.
● Select the check box to enable vWorkspace Gateway.
● vWorkspace Gateway— Enter the IP address of the vWorkspace gateway.
f. If you select Other, you must enter the IP address of the broker server in the Broker Server box.
3. Click OK to save the settings.
Configuring the WDA settings on Dell Wyse ThinOS
Use this tab to configure the WDM and CCM settings.
To configure the WDA settings, do the following:
1. From the desktop menu, click System Setup, and then click Central Configuration.
The Central Configuration dialog box is displayed.
2. Click WDA, and use the following guidelines.
WDM is selected by default. WDA service automatically runs after the client starts up.
Figure 1. Central Configuration
26
Wyse 3040 thin client on ThinOS