Administrator Guide

• Upside-down
4 Click the ON/OFF button to switch between dual display and mirror mode in a dual monitor conguration.
5 Click the ON/OFF button to enable the Set as primary option. This option allows you to set the selected monitor as primary.
6 Click the ON/OFF button to enable the Monitor On/O option. This option allows you to switch o and switch on the preferred
monitor in a dual monitor conguration.
Setting the date and time
1 Click the Date and Time tab to set the date and time on your thin client.
The Date and Time screen enables you to set the device’s date, time, time zone, and whether or not the device should sync its time
with an NTP (Network Time Protocol) server. You can congure the Date and Time either manually or automatically. The date, month
and the year along with the time is displayed at the top of the screen.
The Time Format can be changed by using the Time Format drop-down list, and the Time Zone can be changed by using the Time
Zone drop-down list. The default time zone is America/Los_Angeles. Both changes can be performed regardless of the ON or OFF
state of the Set Time Automatically switch.
NOTE: By default, the Date and Time screen is available only in Admin mode
Figure 3. Date and time settings
2 To congure the Date and Time settings manually when the Set Time Automatically switch is in OFF position.
a Click the date eld and select the year, month and date.
Any changes performed in the date eld such as, the time format is selected as 24 Hours or an additional AM/PM format, is
displayed at the top of screen.
The time eld consists of Hour and Minute drop-down list.
b Click Save to save the changes. Clicking Save when Set Time Automatically switch is in the OFF state also disables NTP
synchronization.
NOTE
: The Date and Time screen detects whether or not the NTP daemon is activated. By default, the NTP daemon is
deactivated. The manual setting time zone/date/time page is displayed, if the NTP daemon is deactivated. Otherwise,
the auto setting time zone page is displayed.
3 To congure the Date and Time automatically:
a Click the Set Time Automatically button, to turn on the automatic settings. Note that internet access is required to use this
option. Turning on this option activates the NTP daemon and enables the NTP daemon to start syncing the device’s time with
the specied NTP server.
Conguring
thin client settings locally 13