Users Guide

—Remove the four (4) monitor screws from the back of the monitor and set them aside.
—Position the P-series mount's central section on the back of the monitor. Tilt and slide the mount’s top tabs into the dedicated tab
slots, and then rmly slide down the bottom edge of the mount until it snaps in place.
—Install the P-series mount to the back of the monitor using the four monitor screws set aside earlier (do not over-tighten).
CAUTION
: If you need to remove the P-series mount, remove the monitor screws and then press the lower quick
release button(in black) on the monitor, not the upper release button(in silver) on the mount.
8 Mounting the thin client