Reference Guide

Parameter Description

rotate-left, rotate-normal, and rotate-right are supported as legacy

parameters. These parameters rotate the framebuer for monitors that

do not actually support rotation. Specifying these parameters requires

monitors to be physically rotated. For monitors that support rotation,

these parameters are not necessary.

This key value is to reset both monitors to default settings. (Optimal

resolutions in horizontal placement and MON1 on the left as primary

display).

DDC

Resets all the monitors to default layout and default resolutions – The

default layout is all in HORIZONTAL placement, Primary is MON1 and

resolutions are optimal.

Horizontal

For Example: DisplaySettings=Horizontal (which is equal to

DisplaySettings= <default>) OR DisplaySettings=Horizontal MON1

primary 1920x1080 MON2 1920x1200 MON3 1920x1200

This single Horizontal (with capital H) key value without any parameter

is used to reset both the monitors to DDC mode as it is in default

settings. There can be parameters as in MON1 MON2 and MON3 format

as described above. The result is to set the monitors in horizontal

placements with specied individual parameters.

Vertical

For Example: DisplaySettings=Vertical (which is equal to

DisplaySettings= <default>) OR DisplaySettings=Vertical MON1 primary

1920x1080 MON2 1920x1200 MON3 1920x1200

This single Vertical (with capital V) key value is used to set both

monitors to DDC resolutions, but in vertical placement with default

MON1 on the top.

MON3...MON2 … MON1…

With individual monitor with their specic parameters in place, but swaps

the MON2 at the beginning of the string, followed by MON1 will be

placed MON2 on the left and MON1 on the right. This is equivalent of

MON1 on-right MON2 on-left. For Example: MON2 MON1 = MON1 on-

right MON2 and MON3on-left

Mirror <rotate{normal, left, right, inverted}, {resolution}>

It sets the monitors in mirror mode with given resolution and rotation.

JetDirectPrinter=<printer address>

For Example: JetDirectPrinter=<printer address> <options>

For parameter options used in the command line, see JetDirectPrinter

in Printer Parameters Options.

Mouse.MouseSpeed={value 0 to 6 and <default>} It Species the speed when you are moving the mouse.

0 – Slowest

6 – Fastest

Default: Set to system default by using <default> in INI le.

18 Peripheral Settings Parameter Options