Administrator Guide

• Select the check box to enable automatic reconnection at logon.
NOTE:
If you enable the automatic reconnection, you are able to select from the reconnection options. Click either of the
options where you can connect to the disconnected sessions only or connect to both active and disconnected
sessions.
• Select the check box to enable automatic reconnection from the button menu.
NOTE: If you enable the automatic reconnection, you are able to select from the reconnection options. Click
either of the options where you can connect to the disconnected sessions only or connect to both active and
disconnected sessions.
• Account Self-Service Server— Enter the IP address of the Account self-service server.
• XenApp — Use this option, if you want to set default settings to XenApp.
• XenDesktop— Use this option, if you want to set default settings to XenDesktop.
c If you select the VMWare view, use the following guidelines:
• Broker Server— Enter the IP address/Hostname/FQDN of the Broker Server.
• Auto Connect List—Enter the name of the desktops that you want to launch automatically after logging in to the respective
broker. More than one desktop can be entered. Each desktop name is separated by semi-colon, and is case-sensitive.
• Security mode—Select the preferred Security mode from the following options:
• Warning —Warn Security requires FQDN address with self-signed certicate, or without any certicate, but
corresponding warning message is displayed for user to continue.
• Full—Full Security requires FQDN address with domain certicate.
• Low—Security allows FQDN/IP address with/without certicate.
• Default— Follows global security mode settings.
For PCoIP enabled clients, an additional Connection Protocol drop-down list for protocol selection is available. By default, the
option is set to Server Default.
From the Connection Protocol drop-down list, select the type of protocol connection. The available options are:
• Server Default— Select this protocol connection to display the desktop with default protocol as congured in the VMware
View Admin console, for each pool in the broker. If a desktop pool is congured with default protocol as RDP in the View
Admin console, then only the RDP connection of the desktop is displayed in ThinOS after users sign in to the device.
• All Supported—Select this protocol connection to display the desktop in both RDP and PCoIP connections, when a desktop
pool is congured to allow users to select protocol as yes. If a desktop is congured with default protocol as PCoIP and allow
user to select protocol as no, then ThinOS only displays the desktop in PCoIP connection.
• RDP only— Select this protocol connection to display only the desktop in RDP connection. If a desktop pool is congured
with default protocol as PCoIP in the View Admin console, and allow user to select protocol as no, then this desktop is not
displayed in ThinOS after user signs in to the device.
• PCoIP only—Select this protocol connection to display only the desktop in PCoIP connection, for each pool in the broker. If
a desktop pool is congured with default protocol as RDP in the View Admin console, and allow user to select protocol as no,
then this desktop is not displayed in ThinOS after user signs in to the device.
For more information about VMware Horizon View broker, see Using the VMware Horizon View broker and PCoIP.
d If you select the Microsoft, use the following guidelines:
• Broker Server—Enter the IP address/Hostname/FQDN of the Broker Server.
• Auto Connect List—Enter the name of the desktops that you want to launch automatically after logging in to the respective
broker. More than one desktop can be entered. Each desktop name is separated by semi-colon, and is case-sensitive.
e If you select Dell vWorkspace, use the following guidelines:
• Broker Server— Enter the IP address/Hostname/FQDN of the Broker Server.
Conguring
the Connectivity 31