Administrator Guide
NOTE:
The Host Name may be resolved using one of three mechanisms: ICA master browser, DNS or WINS. Master browser is the
only mechanism that can resolve a published application unless manual entry is made in DNS for the application. DNS uses
the default domain name in the network control panel to attempt to construct an FQDN but will also try to resolve the name
without using the default.
e Encryption Level — Allows you to select the security level of communications between the thin client and the ICA server.
Basic (the default option) is the lowest level of security. Basic allows faster communication between the device and the ICA
server because it requires less processing than the higher levels of encryption.
NOTE: The encryption selection applies to the security of communications between the thin client and the ICA server
only. It is independent of the security settings of individual applications on the ICA server. For example, most web
nancial transactions require the thin client to use 128-bit encryption. However, transaction information could be
exposed to a lower level of security if the thin client encryption is not also set to 128 bits.
f Use HTTP for browsing — When selected, the thin client, by default, uses HTTP when browsing.
g Alternate address via rewall — When selected, the thin client uses an alternate IP address returned from the ICA master
browser to get through rewalls. Used for the Windows log on when the connection is activated.
h Display Resolution — Select the display resolution for this connection.
If you select the Published Application option, the Connection Display allows you to select the Seamless Display Resolution
option.
Colors — Select the color depth of the ICA session. If High Colors (16 bits) or True Colors is selected and the ICA server does
not support this color depth, the thin client renegotiates the color depth to the lower value, for example, 256 Colors [8–bits].
i Window mode and Full screen mode — Select the initial view of the application and desktop in a windowed screen or full
screen.
j Auto-connect on start-up — When selected, automatically connects the session on start-up.
k Reconnect after disconnect — When selected, causes the thin client to automatically reconnect to a session after a non
operator-initiated disconnect. If selected, the wait interval is that set in the Delay before reconnecting box (enter the number of
seconds 1–3600) or the user prole for yes (20 seconds) or seconds. The default is 20 seconds, if there is no INI le description
of this connection, or is a Stand-alone user, or simply omitted.
3 Click logon tab, and use the following guidelines:
Advanced Details on
Conguring ICA and RDP Connections 103