Dell Wyse 3040 monitor mount for 2016 E-series and E2417H Dell monitors Installation guide
Notes, cautions, and warnings NOTE: A NOTE indicates important information that helps you make better use of your product. CAUTION: A CAUTION indicates either potential damage to hardware or loss of data and tells you how to avoid the problem. WARNING: A WARNING indicates a potential for property damage, personal injury, or death. Copyright © 2017 Dell Inc. or its subsidiaries. All rights reserved. Dell, EMC, Dell EMC and other trademarks are trademarks of Dell Inc. or its subsidiaries.
Contents 1 Dell monitors using this mount........................................................................................................................4 2 Included in the kit.......................................................................................................................................... 5 3 Mounting the thin client.................................................................................................................................
1 Dell monitors using this mount Dell Wyse 3040 monitor mount for 2016 E-series and E2417H monitors is designed to work with the following monitors: • E1916H • E2016 • E2216H • E2316H • E2417H NOTE: This mount is only designed to work with the Dell monitors listed above. This should not be used with other monitors.
2 Included in the kit Parts provided in the kit include: 1 One Dell Wyse 3040 monitor mount Included in the kit 5
3 Mounting the thin client Use the following instructions for mounting the thin client to a monitor using the E-series monitor mount: 1 Attaching the E-series mount to the monitor —Place the monitor panel face down on a soft cloth or cushion. —Remove cover plate if attached. —Remove the four (4) monitor screws from the back of the monitor and set them aside. NOTE: For ease of installation, position the monitor with the base of the stand hanging over the edge of the table.
—Position the E mount on the back of the monitor and attach it using the same monitor screws (do not over-tighten). NOTE: The four clips must be in the vertical orientation. 2 Attaching the thin client —Align the thin client over the bracket and gently push the client in place until you hear a click. Make sure that the orientation of the thin client is the same as shown below.
3 Connecting cables —Make all desired connections, and then connect the power adapter’s AC power cord into an electrical outlet. NOTE: To remove the client, gently pull the client to release it from the mount.
