Reference Guide

mute={0, 1, 2, 3}
[mic_vol={high, middle, low} or {0-25}]
[mic_mute={0, 1}]
[min_cache={1-50}]
[EnableSpeaker={yes, no}][
middle — medium volume
low — minimum volume
Values of 0-25 provide more exact volume level
mute — Default is 0. Option to enable/disable mute.
0 — no mute
1 — mutes audio
2 — mutes audio and system beep
3 — mutes system beep
mic_vol — Default is medium. Option to set volume levels to high,
middle or low.
high — maximum volume
middle — medium volume
low — minimum volume
Values of 0-25 provide more exact volume level.
mic_mute — Default is 0.
0 — no mute
1 — mutes audio
min_cache — Default is 1. This option is for conguring ThinOS
audio playback minimum buering amount in ten millisecond units.
This can be used when network bandwidth is not large enough to
play audio smoothly.
In such cases, set min_cache higher, so that ThinOS will buer
more audio data before playing the audio.
1 – ThinOS will buer at least 10 ms of audio data when playing
audio.
...
50 – ThinOS will buer at least 500 ms (0.5s) of audio data when
playing audio.
EnableSpeaker — Default is yes. Yes/no option to enable the
internal loud speaker.
Device=bluetooth
[Disable={yes, no}]
Set the parameter to disable bluetooth devices. The default value is
no. The value is stored into NVRAM. If you set Disable=yes, the
bluetooth devices are not initialized.
Device=camera
[format=raw]
[width={camera supported width}]
[height={camera supported height}]
[fps={camera supported fps}]
Specify the ThinOS local camera settings.
format — Support only for raw video type; format=raw is xed.
width — The width of the resolution that the local camera
supports.
height — The height of the resolution that the local camera
supports.
Parameters for WNOS INI, {username} INI, and $MAC INI les 55