Reference Guide

port—The TCP port of the thinprint client. The default port
number value is 4000. The port number value must be less than
65535.
Connection settings for wnos.ini les only
Table 4 contains the parameters used for conguring the connection settings. The default values are underlined.
Table 6. Connection Settings: wnos.ini les only
Parameter Description
AddCerticate=lename
password={plain text password}
Password-enc={encrypted password}
AddCerticate — Species a certicate le residing in the
subfolder cacerts under the wnos folder to load on platforms with
nand ash, or on the memory. The length of the lename, including
the trailing period and the le extension, is limited to 64 characters.
AddCerticate must be used when conguring the Citrix Secure
Gateway PNAgent Interface (PNAgent/Lite servers) in the
Network Setup dialog box.
Adding certicates are required if the user CSG environments use
certicate agents that are not covered by the built-in certicates.
The certicates are used to validate server identities by the thin
client. Supported les include .crt le on ICA CSG; .cer and .pfx in
802.1x. Password and Password-Enc are specially used with PFX
les.
CaradigmServer=vip list
[EGPGroup=group name]
[EnableLogO={yes,no}]
[SecurityMode={default, full, warning, low}]
CaradigmServer=vip list contains a list of VIP addresses with
optional TCP port number of Caradigm servers. EGPGroup denes
the user group name. If EnableLogO=yes is specied, the user is
logged o from the session before system signs o. Otherwise the
session is disconnected. The logged o user has a timeout value
which can be set using SessionCong parameter
SessionLogOTimeout.
The default timeout value is 1, if no SessionLogOTimeout is
specied.
SecurityMode species the SSL certication validation policy.
If set to default, it applies the SecurityPolicy setting.
If set to full, the SSL connection needs to verify server certicate.
If it is untrusted, drop the connection.
If set to warning, the SSL connection needs to verify server
certicate.
If it is untrusted, it is up to you to continue or drop the connection.
If set to low, the server certicate is not checked. The value is
persistent, the default value of the setting is default.
Community=community
[Encrypt={yes, no}]
Species the SNMP community name. A string up to 31 characters
are allowed. After the value is specied, it is saved in the non-
volatile memory.
If encrypt=yes, an encrypted string is used as a community name.
The default value is set to no.
Parameters for WNOS INI les only 19