Administrator Guide

5. Go to Control Panel > Devices and Printer, and verify if the printer driver is automatically installed.
After the printer drive installation is complete, the redirected printer is listed in the Printers section.
Configure the Citrix UPD printer
Use of Citrix Universal Printer Driver (Citrix UPD) ensures that all printers that are connected to the thin client can also be used
from a virtual desktop or application session without integrating a new printer driver in the data center. Citrix UPD is the base of
Citrix Universal Printer. It is an autocreated printer object that uses the Citrix UPD and is not tied to any specific printer defined
on the client.
About this task
This section describes how to configure the Citrix UPD usage on your thin client.
Steps
1. Connect a printer to the ThinOS client.
2. From the desktop menu, click System Setup > Printer.
The Printer Setup dialog box is displayed.
3. Enter the name of the printer in the Printer Name box.
4. Enter any string of the Printer identification in the Printer Identification box.
5. Select the type of the printer class from the drop-down list, select the check box to enable the printer device, and click OK.
NOTE: In ThinOS 9.0, only PS class is supported.
6. Start a Citrix Virtual Apps and Desktops application connection.
7. Open the Devices and Printers in the desktop or application. Notice that the printer is mapped as the UPD printer by
default.
Next steps
To enable the printer server policies for Citrix UPD printer, see the Citrix documentation at docs.citrix.com.
98
Configuring the connection broker—Citrix