Administrator Guide

● LEAP—Select this option, and click Properties to configure the Authentication Properties dialog box. Be sure to
use the correct username and password for authentication. The maximum length for the username or the password is
31 characters.
● PEAP—Select this option, and click Properties to configure the Authentication Properties dialog box. Be sure to
select either EAP_GTC or EAP_MSCHAPv2, and then use the correct username, password, and domain. Validate
Server Certificate is optional.
● FAST—Select this option, and click Properties to configure the Authentication Properties dialog box. Be sure to
select either EAP_GTC or EAP_MSCHAPv2, and then use the correct username, password, and domain.
NOTE: During the initial connection with EAP-FAST, when there is a request for a Tunnel PAC from the
authenticator, the PAC is used to complete the authentication. The first-time connection always fails, and
the subsequent connections succeed. Only automatic PAC provisioning is supported. The user/machine PAC
provisioning that is generated with CISCO EAP-FAST utility is not supported.
When EAP-MSCHAPV2 or EAP-GTC is selected for PEAP or FAST authentication, an option to hide the domain
is available. Username and password boxes are available for use, but the domain text box is disabled. When EAP-
MSCHAPV2 or EAP-GTC is selected for PEAP or FAST authentication, a check box to enable the single sign-on
feature is available.
3. Click OK to save your settings.
Configure the WLAN settings
About this task
This section describes how to configure the wireless settings on your thin client.
NOTE:
On the Wyse 5070 Thin Client with an optional SFP module or RJ45 module, you cannot configure the wireless
settings.
Steps
1. From the desktop menu, click System Setup > Network setup.
The Network Setup dialog box is displayed.
2. Click the WLAN tab, and configure the following options:
Figure 16. WLAN tab
54
Configuring connectivity