Administrator Guide

4. To set the power and sleep options when the thin client is plugged in, change the following options in Power And Sleep >
When plugged in:
a. From the Power And Sleep drop-down list, select Power off or Sleep.
b. From the Timer drop-down list, select the duration for the thin client to be idle to enter sleep mode or power off.
c. From the When I close the lid drop-down list, select any of the following options to set the behavior of the thin client
when the lid is closed:
● Turn off the built-in display—Turns off only the built-in display.
● Turn off the built-in and external displays—Turns off all the displays that are connected to the thin client.
● Shut down device—shuts down the thin client
NOTE: Power And Sleep > When plugged in > When I close the lid drop-down list is only available in Wyse 5470
Thin Client.
5. Click OK to save your settings.
Configure the display settings
About this task
This section provides information about how to configure the display settings for the connected displays.
NOTE: On Wyse 5470 Thin Client, the built-in display stays on by default.
By default, the device uses the span mode if a new display is connected. When you change the display settings for the current
display setup, the settings are preserved. If you connect the same display again, the device sets the monitor layout (including
the disable monitor setting) according to the saved layout.
Steps
1. From the desktop menu, click System Setup > Display.
The Display Setup dialog box is displayed.
2. In the Display Setup dialog box, configure any of following options:
Figure 40. Display
● Select the Mirror check box to enable all connected displays to use the same display settings configured on the primary
display.
Configuring the thin client local settings
153