Administrator Guide

3. Click OK to save your settings.
Configure the LPDs settings
About this task
This section describes how to configure the LPD settings on your thin client.
Steps
1. From the desktop menu, click System Setup > Printer.
The Printer Setup dialog box is displayed.
2. Click the LPDs tab, and do the following when printing to a non-Windows network printer:
Figure 43. LPD
NOTE: Be sure to check with your vendor that the printer can accept Line Printer Request print requests.
a. Select LPD—Select the LPD port from the drop-down list.
b. Printer Name —Enter the name of the printer. If you do not specify a printer name, the LPD queue name is used
automatically.
c. Printer Identification—(Required) Enter the type or model of the printer in the exact text of the Windows printer
driver name—including capitalizations and spaces.
Printer mapping in a Citrix session on ThinOS uses Citrix UPD (Universal Printer Driver). You can enter any string in the
Printer Identification field.
d. LPD Hosts—(Required) The DNS or WINS name of the server for the network printer. An IP address of the printer on
the network can also be entered.
e. LPD Queue Name—(Required) An LPD host maintains a named queue for each supported printer. Enter the name of
the queue associated with the printer to be used.
This name can be different for each vendor. This field is required and must be correct so that the network printer
accepts incoming print jobs properly.
f. Printer Class—Select the printer class from the drop-down list as PS.
g. Enable the printer device—Must be selected to enable the printer. It enables the device to be displayed on the remote
host.
3. Click OK to save your settings.
158
Configuring the thin client local settings