Users Guide

1. Parent interface — Type the name for your parent interface.

2. VLAN ID — Enter the value for the VLAN id.

3. VLAN interface name — Type the name for your VLAN interface.

4. Cloned MAC address — Type the cloned MAC address.

5. MTU —Specifies the size (in bytes) of the largest protocol data unit that the protocol layer can pass onwards.

6. Flags—Select the Reorder headers, Generic VLAN Registration Protocol (GVRP), Loose binding, and Multiple VLAN

Registration Protocol (MVRP) check boxes to enable the respective functions for your VLAN connection.

b) To configure the General tab, IPv4 Settings tab, and IPv6 Settings tab for VLAN connection, see the configuration details for

Bond connection in this section.

7. Click Save to save your settings.

Configuring peripherals settings on Wyse

ThinLinux

On the System Settings page, click the Peripherals icon. The following tabs are displayed on the left pane of the System Settings page.

• Keyboard

• Mouse

• Printers

• Sound

Setting the keyboard preferences

The Keyboard setting page enables you to set the Keyboard preferences and make the Keyboard layout.

NOTE:

By default, the Keyboard screen is available in both User mode and Admin mode. Any changes made through

Keyboard preferences screen is saved and continued for the built-in thinuser

Figure 9. Keyboard Preferences

1. Click the ON/OFF button to disable or enable the Key presses repeat when held down option after you log in to the session.

2. Move the slider to the left to decrease the repeated delay time of the pointer or move the slider to the right to increase the repeated

delay time of the pointer.

3. Move the slider to the left to decrease the repeat rate of the pointer or move the slider to the right to increase the repeat rate of the

pointer.

4. In the keyboard layout box, select the layout you want to use and click Add to include the preferred layout in the currently added

layouts list.

5. Select the preferred keyboard layout from the currently added layouts list, and click Set as Default Layout button to set the default

layout.

Wyse 3040 thin client on ThinLinux