Users Guide

• vWorkspace Gateway— Enter the IP address of the vWorkspace gateway.
f) If you select Other, you must enter the IP address of the broker server in the Broker Server box.
3. Click OK to save the settings.
Configuring the WDA settings on Dell Wyse
ThinOS
Use this tab to configure the WDM and CCM settings.
To configure the WDA settings, do the following:
1. From the desktop menu, click System Setup, and then click Central Configuration.
The Central Configuration dialog box is displayed.
2. Click WDA, and use the following guidelines.
WDM is selected by default. WDA service automatically runs after the client starts up.
Figure 1. Central Configuration
If the first discovery, for example, the WDM service is not successful, then it seeks for the next priority, for example, CCM service.
This continues till a discovery is successful. If all discoveries fail, then it is started again automatically after a fixed time (24 hours).
a) WDM Servers — Enter the IP addresses or host names, if WDM is used. Locations can also be supplied through user profiles, if
user INI profiles are used.
b) DNS Name Record — (Dynamic Discovery) Allows devices to use the DNS host name lookup method to discover a WDM server.
Wyse 3040 thin client on ThinOS
25