Users Guide

a) Add— Use this option to add and configure a new SSID connection.

You can configure the SSID connection from the available security type options.

b) After you configure the SSID connection, the added SSID connection is listed on the page of the WLAN tab.

c) Remove — Use this option, if you want to remove a SSID connection by selecting the SSID connection from the list.

d) Properties — Use this option to view and configure the authentication properties of a SSID connection that is displayed in the

list.

e) Select the Disable Wireless Device check box, if you want to disable a wireless device.

3. Click OK to save the settings.

Configuring peripherals settings on Wyse ThinOS

The Peripherals dialog box enables you to configure the settings for the keyboard, mouse, camera, and printer.

Configuring keyboard settings

To configure the Keyboard settings:

1. From the desktop menu, click System Setup, and then click Peripherals.

The Peripherals dialog box is displayed.

2. Click the Keyboard tab and set the Character Set, Keyboard Layout, Delay Before Repeat and Repeat Rate parameters. The following

table explains the parameters present on the Peripherals dialog box.

Table 1. Keyboard parameters

Parameter Description

Character Set Specifies the character set. Each character is represented by a

number. The ASCII character set, for example, uses the numbers

0 through 127 to represent all English characters and special

control characters. European ISO character sets are similar to

ASCII, but they contain additional characters for European

languages.

Keyboard Layout Presently the keyboard languages listed in the Keyboard layout

drop-down list are supported. The default value is English

(United States).

Delay Before Repeat Specifies the repeat parameters for held-down key. Select the

Delay before repeat value as either 1/5 second, 1/4 second,

1/3 second, 1/2 second, 3/4 second, 1 second, 2 seconds, or

No Repeat. The default is 1/3 second.

Repeat Rate Select Slow, Medium, or Fast. The default value is Medium.

3. Click OK to save the settings.

Configuring mouse settings

To configure the mouse settings:

1. From the desktop menu, click System Setup, and then click Peripherals.

The Peripherals dialog box is displayed.

2. Click the Mouse tab to select the mouse speed and mouse orientation.

Wyse 3040 thin client on ThinOS