Users Guide

• Wired

• Network proxy

Figure 3. Network Settings page

Conguring wired network connection settings

To congure the wired connection settings, perform the following steps:

1 Click the Wired tab. The following attributes are displayed if the network cable is connected to your thin client and wired connection is

established.

• IP Address

• Hardware Address

• Default Route

• DNS

NOTE

: After the network is disconnected, only hardware address and last used information are displayed.

2 On the lower-right corner of the page, click the Settings icon to congure the Wired Network connections.

a In the Details tab, the following attributes are displayed.

• IP Address

• Link Speed

• Hardware Address

• Default Route

• DNS

3 Click the Security tab to congure the 802.1x security settings.

a Click the ON button to enable the 802.1x Security for your network connection.

b From the Authentication drop-down list, select the type of authentication you want to set for your network connection. The

available options are:

• MDS

• TLS

• FAST

• Tunneled TLS

• Protected EAP (PEAP)

c If the authentication type is selected as MD5, you must congure the following options.

Networks