Administrator Guide
• Bond
• Bridge
• VLAN
2 Click VPN to add a VPN network connection. You must import a le from the stored location to congure the VPN settings.
3 Click Bond to add and congure the Bond network connection for your thin client.
a Click the General tab to select or deselect the following check boxes.
• Automatically connect to this network when it is available.
• All users may connect to this network.
• Automatically connect to VPN when using this connection.
b Click the Bond tab, and congure the following options:
1 Type a name for your network interface.
2 The number of bonded connections that are set up are listed here. To add a new bond connection, click the Add button
and select the type of connection you want to create. The available options are Ethernet and InniBand.
3 Select the type of Network Mode from the drop-down list. The available options are:
• Round-robin
• Active Backup
• XOR
• Broadcast
• 802.3ad
• Adaptive transmit load balancing
• Adaptive load balancing
4 Link Monitoring — Select the type of link monitoring from the drop-down list. The available options are:
• MII (recommended)
• ARP
5 Enter the time in ms for the link up delay duration.
6 Enter the time in ms for the link down delay duration.
c Click the IPv4 Settings tab, and do the following:
1 From the drop-down list select the following method for IPv4 authentication.
• If Automatic (DHCP) method is selected, you must congure the following options:
1 Additional DNS Servers — Type the IP addresses of domain name users that are used to resolve host names. Use
commas to separate multiple domain name server addresses.
2 Additional Search Domains — Type the IP addresses of domains used when resolving host names. Use commas to
separate multiple domains.
3 DHCP client ID — Enter the ID for the DHCP client. This client identier allows the network administrator to
customize your computer’s conguration.
4 Require IPv4 addressing for this connection to complete — The IPv4 address is required to complete the
connection. If the IPv4 address is not available, then the connection is not congured.
5 Click the Routes button to edit IPv4 routes for Bond connection.
a Click Add to add an IP address. After an IP is added, Netmask, Gateway and Metric specic to that IP are
displayed.
b Select the check box if you want to ignore the automatically obtained routes.
c Select this check box if you want to use your connection only for resources on that particular network.
• If Automatic (DHCP) addresses only method is selected, you must congure the following options:
1 DNS Servers — Type the IP addresses of domain name users that are used to resolve host names. Use commas
to separate multiple domain name server addresses.
36
Conguring thin client settings locally