Administrator Guide

• IP Address
• Hardware Address
• Default Route
• DNS
NOTE: After the network is disconnected, only hardware address and last used information are displayed.
2
On the lower-right corner of the page, click the Settings icon to congure the Wired Network connections.
a In the Details tab, the following attributes are displayed.
• IP Address
• Link Speed
• Hardware Address
• Default Route
• DNS
3 Click the Security tab to congure the 802.1x security settings.
a Click the ON button to enable the 802.1x Security for your network connection.
b From the Authentication drop-down list, select the type of authentication you want to set for your network connection. The
available options are:
• MDS
• TLS
• FAST
• Tunneled TLS
• Protected EAP (PEAP)
c If the authentication type is selected as MD5, you must congure the following options:
Table 3. MD5
conguration
Parameter Description
Username Enter the Username for the network connection.
Password Enter the password you want to set for the connection.
Ask for this password every time If this check box is selected, you will be prompted to enter the
password every time when you connect to the network.
Show Password Select this check box if you want to allow the user to view the
hidden password.
d If the authentication type is selected as TLS, you must congure the following options.
Table 4. TLS
Parameter Description
Identity Enter your Identity.
User certicate Select the User certicate from the list or upload your
personal certicate stored locally.
To upload your personal certicate, click the Folder icon, and
then browse to the location where you have stored the
certicate.
CA Certicate Select the CA certicate from the list or upload your CA
certicate stored locally.
Conguring thin client settings locally 31