Administrator Guide
c Select the Disable Wireless Device check box, if you want to disable a wireless device.
• Always: Click this radio button if you want to disable the wireless device at all times.
• EnetUp: Click this radio button if you want to disable the wireless device whenever the wired network is connected.
d Click IPCong to congure the IPv4 settings for the wireless connection. To set the IPv4 connection to use DHCP or the
specied static IP address, do the following:
1 Click Properties.
2 If you want to allow your zero client to automatically receive information from the DHCP server, click Dynamically
allocated over DHCP/BOOTP.
3 If you want to manually congure the IP address, click Statically specied IP Address, and provide the IPv4 details.
3 Click OK to save the settings.
IMPORTANT
: From ThinOS Lite version 2.5, device reboot is not required to change the network settings. All the
changes take eect immediately. For example, ThinOS Lite connects to the new wireless SSID immediately without
reboot. However for ARM platforms—Wyse 3010 zero client, and Wyse 3020 zero client—the disable/enable wireless
requires reboot.
Conguring the proxy settings
The network Proxy tab is added to support Wyse Management Suite, HDX Flash Redirection and Real Time Multimedia Engine (RTME).
Conguring
the connectivity 37