Administrator Guide

Figure 138. Trace Route
a Enter Hostname or IP — Enter the IP address, DNS-registered host name, or WINS-registered host name of the target to be
traced
b Data area — Displays round-trip response time and identifying information for each device in the path.
c Start — Executes the tracert command.
d Stop — Terminates the tracert command and leaves the Trace Route dialog box open, so you can read the information posted
in the data area.
The tracert utility traces the path from your zero client to a network host. The host parameter is either a valid host name or an
IP address. The tracert utility sends out a packet of information three times to each device (routers and computers) in the path
and displays the round trip response times and identifying information in the message box.
7 Click the Telnet tab, and do the following:
Performing Diagnostics
165