Owner's Manual

NOTE:
NOTE:
• Your DW
WLAN
Card
must be
capable of
IEEE
802.11n
operation,
and a
channel
that
provides
40 MHz
bandwidth
operation
must be
available.
• If you are creating a profile for connecting to a network, it is not necessary to select the channel. When you
connect to the host network, the software detects the channel and bandwidth settings of the host network and
automatically uses those settings.
• Operating your ad hoc network on a 40 MHz bandwidth channel does not necessarily increase throughput if the
environment is busy or noisy. Furthermore, the "good neighbor" policy that is used to minimize neighboring-
channel interference on infrastructure networks is not supported for ad hoc networks that are operating on a 40
MHz bandwidth channel. Therefore, operating your ad hoc network on a 40 MHz bandwidth channel is likely to
cause twice as much neighboring-channel interference with other ad hoc connections in your area than when
operating on a 20 MHz bandwidth channel.
4. If you want the profile to be temporary, in the Remove after list, select the period of time you want the
profile to be available.
-or-
• If you want the profile to be permanent, select Never.
5. In the Network authentication list, select either Open or Shared.
• If you
want
the
network
that you
are
creating
to use
no
security,
or if the
network
that you
want to
connect
to uses
no
security,
select
Open.
• If you want the network that you are creating to use WEP security, or if the network that you want to connect to