Manualshelf

Owner's Manual

ManualsBrandsDell ManualsNetworkDell Wireless 1390/1395/1397/1490/1501/1505/1510/1520 WLAN Card (SW version 5.60.48)
11121314151617181920
NOTE: Whenever you install a fresh driver, the value is reset to the default setting. The default value is set to Disabled
to support interoperability issues with Cisco v4.8 VPN client.
VLAN-tagged packets.
Auto
Enabled
Disabled (default)
Wake-Up Mode
The Wake-Up Mode property enables or disables the capability of the DW WLAN Card to wake up the computer from a low-
power state when the adapter receives a network wake-up packet.
All. Loss of Link, Magic Pattern, and Net Pattern are considered in wake pattern matching.
LossOfLink. Wakes up the machine if the wireless STA loses its association with the AP in Wake mode. Loss of link is
detected by three events:
• The wireless STA receives a deauth/disassoc frame from the AP.
• The wireless STA stops receiving a beacon from the AP for a pre-specified interval (8 seconds).
• The wireless STA receives a retrograde timing synchronization function (TSF) in the AP beacon.
Magic & WakeUp Frame (default). Both Magic Pattern and Net Pattern are considered in wake pattern matching.
Magic Frame & LossOfLink. Both Magic Pattern and Loss of Link are considered in wake pattern matching.
Magic Packet. Only Magic Pattern is considered in wake pattern matching.
None. Pattern Matching is disabled.
Wake Up Frame. Only Net Pattern is considered in wake pattern matching.
Wake Up Frame & LossOfLink. Both Net Pattern and Loss of Link are considered in wake pattern matching.
WMM
The Wi-Fi Multimedia (WMM
®
) property enables Quality of Service (QoS) for audio, video, and voice applications over a
wireless network by prioritizing streams of content and optimizing the way the network allocates bandwidth among competing
applications.
Auto (default). With WMM set to Auto, when the wireless client connects to the wireless router/AP, and the wireless
router/AP has
Unscheduled Automatic Power Save Delivery (UAPASD) enabled, the wireless client is allowed to enter
Power Save mode. If the AP does not support UAPSD, the wireless client cannot enter Power Save mode. If this is the
case, the battery in the client computer discharges more quickly and must be recharged more frequently.
Enabled. The wireless client enters Power Save mode for WMM associations independent of whether the AP has
UAPSD enabled or disabled.
Disabled. The wireless client does not have WMM association.
WZC IBSS Channel Number
The WZC IBSS Channel Number property selects the independent basic service set (IBSS) channel number on which to
operate when WZC is managing your wireless networks. The default setting is 11.