User Manual
Table Of Contents
- OptiPlex 7000 Tower Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of OptiPlex 7000 Tower
- Side cover
- Front bezel
- Hard-drive assembly
- 3.5 in. hard-drive assembly
- Solid-state drive
- WLAN card
- Coin-cell battery
- Memory module
- Expansion card
- Graphical processing unit
- Slim optical-drive
- Slim optical-drive bracket
- Speaker
- Power-supply unit
- Processor fan and heat-sink assembly
- Processor
- Communication card
- Chassis fan
- Voltage regulator heat sink
- Power button
- Intrusion switch
- SD card reader (optional)
- Optional modules
- Removing optional DisplayPort module
- Installing optional DisplayPort module
- Removing optional VGA module
- Installing optional VGA module
- Removing optional HDMI module
- Installing optional HDMI module
- Removing optional Serial module
- Installing optional Serial module
- Removing optional Type-C module
- Installing optional Type-C module
- Removing optional Thunderbolt 4 module
- Installing optional Thunderbolt4 module
- Removing internal antenna
- Installing internal antenna
- System board
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Getting help and contacting Dell
Removing and installing components
NOTE: The images in this document may differ from your computer depending on the configuration you ordered.
Recommended tools
The procedures in this document may require the following tools:
● Phillips screwdriver #0
● Phillips screwdriver #1
● Plastic scribe
Screw list
NOTE: When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and
then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is
restored when the component is replaced.
NOTE: Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when
replacing a component.
NOTE: Screw color may vary with the configuration ordered.
Table 1. Screw list
Component Screw type Quantity Screw image
M.2 2230/2280 Solid-state
drive
M2x3.5 1
WLAN card M2x3.5 1
Power-supply unit #6-32 4
Processor fan and heat-sink
assembly
Captive screw 4
VR heat sink #6-32 (Captive) 2
SD card reader (optional) #6-32 1
System board #6-32
M2x4
6-32
1
3
7
2
Removing and installing components 11