Service Manual

Steps
1. Connect the fan cable to the connector on the system board.
2. Turn the fan assembly over.
3. Press the release tab on the fan assembly and place it on the system until it clicks into place.
Next steps
1. Install the speaker.
2. Install the side cover.
3. Follow the procedure in after working inside your computer.
Heat sink
NOTE: This section applies to 35 W and 65 W configuration systems.
Removing the heat sink
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the fan assembly.
Removing and installing components
27