Owner`s manual

Troubleshooting Your Wide LCD Monitor 91
Poor picture quality when using a
device connected to the ANT/Cable
(coaxial) connector
1 Ensure wide LCD monitor is selected as the input source in the
Input Select menu. See "Input Select Menu" on page 85 for
more information.
2 Press Menu on the remote control, select Setup , and then select
Channel Setup . This resets the channels on your remote.
3 Check the aspect ratio settings in the TV Menu. Press the Menu
button on the remote control and select Size . For more
information on using the TV Menu, see "Using the TV Menu"
on page 84.
4 Reset the original factory defaults. Press Menu on the remote
control, select
Setup , and then select Factory Reset .
5 Adjust the color temperature. Press Menu on the remote
control, select
Picture , and then select Color Temperature .
6 The problem may be with your device, contact your service
provider.
Nothing appears on my wide LCD
monitor
1 Ensure the wide LCD monitor is turned on.
2 Verify that all the cables are properly connected to the wide
LCD monitor, including the power cable.
3 Check to see if there is a blue or amber light on the lower,
right-hand corner of the wide LCD monitor. A blue light
indicates the wide LCD monitor is on. An amber light, means
the wide LCD monitor is in power save mode.
4 Ensure the proper source is selected in the Input Select menu.
See "Input Select Menu" on page 85 for more information.
5 Reconnect any devices that are currently connected to the wide
LCD monitor. If you are using multiple devices, connect and
test one device at a time.
6 Connect another device that you know is working properly.
7 Reset the original factory defaults. Press Menu on the remote
control, select Setup , and then select Factory Reset .
Problem Possible Solution