Reference Guide

13
2.4.1.3 Indicator LEDs
There are 4 bicolor (power, ENET and WLAN) LEDs which operate as follows:
Table 4 - AP-114 Indicator LEDs
Label Function Action Status
PWR AP power / ready status Off No power to AP
Red Initial power-up condition
Flashing – Green Device booting, not ready
On – Green Device ready
ENET Ethernet Network Link
Status / Activity
Off Ethernet link unavailable
On – Amber 10/100Mbps Ethernet link
negotiated
On – Green 1000Mbps Ethernet link
negotiated
Flashing Ethernet link activity
2.4GHz 2.4GHz Radio Status Off 2.4GHz radio disabled
On – Amber 2.4GHz radio enabled in non-HT
WLAN mode
On – Green 2.4GHz radio enabled in HT
WLAN mode
Flashing – Green 2.4GHz Air monitor
5GHz 5GHz Radio Status Off 5GHz radio disabled
On – Amber 5GHz radio enabled in non-HT
WLAN mode
On – Green 5GHz radio enabled in HT WLAN
mode
Flashing – Green 5GHz Air monitor
2.5 AP-115
This section introduces the Aruba AP-115 Wireless Access Point (AP) with FIPS 140-2 Level 2 validation.
It describes the purpose of the AP, its physical attributes, and its interfaces.
The Aruba AP-115 is high-performance 802.11n (3x3:3) MIMO, dual-radio (concurrent 802.11a/n + b/g/n)
indoor wireless access points capable of delivering combined wireless data rates of up to 900Mbps. This
multi-function access point provides wireless LAN access, air monitoring, and wireless intrusion detection
and prevention over the 2.4-2.5GHz and 5GHz RF spectrum. The access points work in conjunction with