Reference Guide

9
 1 x USB 2.0 port
The module provides the following power interfaces:
 48V DC via Power-over-Ethernet (POE)
 12V DC power supply
2.2.1.3 Indicator LEDs
There are 5 bicolor LEDs on the RAP-108, which operate as follows:
Table 2 - RAP-108 Indicator LEDs
Label/Function Function Mode Status
PWR
Power On-Green Device Ready
Flashing-Green Device booting - not ready
Red Initial power-up condition
Off No power
ENET0/ENET1
Ethernet Network
Link Status / Activity On-Green 1000 Mbps link established
Off No Ethernet link
On-Yellow 10/100 Mbps link established
Flashing Ethernet activity
5GHz
5 GHz Radio Status On-Green
5GHz radio enabled in HT WLAN
mode
Flashing 5GHz Air monitor
On-Yellow
5GHz radio enabled in non-HT
WLAN mode
Off 5GHz radio disabled
2.4GHz
2.4 GHz Radio Status On-Green
2.4GHz radio enabled in HT WLAN
mode
Flashing 2.4GHz Air monitor
On-Yellow
2.4GHz radio enabled in non-HT
WLAN mode
Off 2.4GHz radio disabled