Reference Guide

7
2.1.1.2 Interfaces
The module provides the following network interfaces:
 3 x 10/100 Base-T Ethernet (RJ45) ports
 1 x console interface (proprietary connector - disabled in FIPS mode by TEL)
 802.11a/b/g/n Antenna Interfaces (Internal)
The module provides the following power interfaces:
 12V DC using supplied AC adapter (RAP-3WN)
 48V DC using supplied AC adapter (RAP-3WNP)
2.1.1.3 Indicator LEDs
There are 5 bicolor (power, ENET and WLAN) LEDs which operate as follows:
Table 1- RAP-3WN/WNP Indicator LEDs
Label Function Action Status
PWR AP power / ready status Off No power to AP
Red Initial power-up condition
Flashing – Green Device booting, not ready
On – Green Device ready
E0/E1/E2 Ethernet Network Link
Status / Activity
Off Ethernet link unavailable
On – Amber 10/100Mbs Ethernet link
negotiated
On – Green 1000Mbps Ethernet link
negotiated
Flashing Ethernet link activity
WLAN 2.4GHz Radio Status Off 2.4GHz radio disabled
On – Amber 2.4GHz radio enabled in non-HT
WLAN mode
On – Green 2.4GHz radio enabled in HT
WLAN mode
Flashing – Green 2.4GHz Air monitor
PSE (RAP-
3WNP only)
Power over Ethernet
indicator
Off No sourcing PoE power
On – Green Sourcing PoE power to an 802.3af
powered device
Flashing PoE power sourcing error