Reference Guide

32|
Aruba 7200 Series Controllers FIPS 140-2 Level 2 Security Policy
Figure 6 Required TELs for the Aruba 7200 Mobility Controller – Right Side

Figure 7 Required TELs for the Aruba 7200 Mobility Controller – Left Side
Figure 8 Required TELs for the Aruba 7200 Mobility Controller – Bottom


Applying TELs
The Crypto Officer should employ TELs as follows:
 Before applying a TEL, make sure the target surfaces are clean and dry.
 Do not cut, trim, punch, or otherwise alter the TEL.
 Apply the wholly intact TEL firmly and completely to the target surfaces.
 Press down firmly across the entire label surface, making several back-and-forth passes to ensure that the label
securely adheres to the chassis.
 Ensure that TEL placement is not defeated by simultaneous removal of multiple modules.
 Allow 24 hours for the TEL adhesive seal to completely cure.
 Record the position and serial number of each applied TEL in a security log.
Once the TELs are applied, the Crypto Officer (CO) should perform initial setup and configuration as described in the next
chapter.