Reference Guide

30|
Aruba 7200 Series Controllers FIPS 140-2 Level 2 Security Policy
Required TEL Locations
The Aruba 7200 Mobility Controller requires a minimum of 15 TELs to be applied as follows:
To Detect Opening the Chassis Lid
 Spanning the left side and right side of the chassis lid where it meets the chassis bottom, as shown in Figures 6,
7, and 8.
 Spanning the front bezel and the chassis lid, as shown in Figures 3 and 4.
 Spanning the expansion slot cover plate and the top of the chassis, as shown in Figures 3 and 4.
To Detect the Removal of Any Module or Cover Plate
 Spanning power supply 1 and the top of the chassis, as shown in Figures 3 and 5. If a second power supply is
installed, a TEL should be applied to it in an identical way to power supply 1.
 Spanning power supply 2 (if installed) and the top of the chassis, or spanning the power supply 2 cover plate and
the top and bottom of the chassis, as shown in Figures 3, 5, and 8.
 Spanning the fan try and the top and bottom of the chassis, as shown in Figures 3, 5, and 8.
To Detect Access to Restricted Ports
 Two labels spanning the RJ-45 and mini-USB serial ports, as shown in figures 4 and 8. Press down on this label
to ensure that it adheres to a sufficient area of the front bezel. The RJ-45 port is raised relative to the bezel so
there will be some air gap under the label in this area. However, the air gap should not be larger than 2-3mm.